Ozone Generator: Model K2 (dual-cell)


SKU: N/A Category:


  • Power supply with micro processor control
  • Dual corona cells
  • Corona discharge ozone generation
  • Non corrosive stainless steel case
  • Water trap air ventilation
    Reduces possibility of damage from water spray
  • Built-in safety devices:
    – Interlinks remove power when door is open to prevent shock from high voltage
    -Flow switch shuts off unit if gas flow is interrupted
    -Fused circuit board (replaceable)
    -Integrated power filtration, surge suppression
    -U.L listed materials for non flammability
  • Built for continuous duty operation
  • Air cooled
  • Integrated Flow Meter
  • Brass oxygen/air inlet and Stainless Steel ozone outlet, barbed fittings
  • ORP sensor hook-up via BNC connector, with optional touch screen

K2 Ozone Generator datasheet (PDF)



  • Dimensions
    (H 21” x W 14” x D 8”)
    Mounting holes 12” across x 19 1/8” top to bottom
    Shipping weight 28 lbs
  • Corona Discharge Ozone Generation
  • 21.2 gm/hr with oxygen (98% O2 @ 6 Lpm) @ 71°f
  • Ozone output purity 4.6% by weight
  • Operating pressure from -2 to 15 psi
  • 110-120 vac 60 hz. U.S. or 220-230 vac 50 hz European units
    Current draw 4.0 amps RMS (460 watts) feed from 10 amp breaker
    Incoming line filter, surge suppressor carries UL, CSE, ETL certifications
    Peak surge suppression 600VAC
  • Temperature from 33 to 90 degrees Fahrenheit
  • Cord length 6’
  • Case material 304 Stainless Steel
  • Brass barb fitting inlet and 316 stainless barb fitting output sized for 1/4″ i.d. tubing
  • Optional aux input allows remote on/off via ORP controller.
  • Optional touch screen controller allows for ORP probe to be attached via BNC connector on unit.


  • Aux input, allows for remote on/off
  • Touch Screen ORP control
  • Ozone Injector Manifold
  • Compression Fittings for I/O
Bookmark the permalink.